Ip Pim Rp-Candidate - Allied Telesis x310-26FT Command Reference Manual

PIM-SM C
OMMANDS
-
IP PIM RP CANDIDATE

ip pim rp-candidate

Overview Use this command to make the router an RP (Rendezvous Point) candidate, using
the IP address of the specified interface.
Use the no variant of this command to remove the RP status set using the ip pim
rp-candidate command.
Syntax ip pim rp-candidate <interface> [priority <priority>|interval
<interval>|grouplist <grouplist>]
no ip pim rp-candidate [<interface>]
Default The priority value for a candidate RP is 192 by default until specified using the
priority parameter.
Mode Global Configuration
Usage Note that issuing the command ip pim rp-candidate <interface> without optional
priority, interval, or grouplist parameters will configure the candidate RP with a
priority value of 192.
Examples To specify a priority of 3, use the following commands:
awplus#
awplus(config)#
To use the ACL numbered 3 to specify the group prefixes that are advertised in
association with the RP address, use the following commands:
awplus#
awplus(config)#
To stop the device from being an RP candidate on vlan2 , use the following
commands:
awplus#
awplus(config)#
Related ip pim rp-address
Commands
ip pim rp-register-kat
C613-50103-01 REV A
Parameter Description
<interface>
Interface name
<priority>
<0-255> configure priority for an RP candidate.
<interval>
advertisement interval specified in the range <1-16383> (in seconds).
<grouplist>
IP access list specifier for standard, expanded or named access lists in
their respective ranges:
[<1-99>|<name>]
configure terminal
ip pim rp-candidate vlan2 priority 3
configure terminal
ip pim rp-candidate vlan2 group-list 3
configure terminal
no ip pim rp-candidate vlan2
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
1236