Ipv6 Pim Dr-Priority - Allied Telesis x310-26FT Command Reference Manual

PIM-SM 6 C
V OMMANDS
6 -
IPV PIM DR PRIORITY

ipv6 pim dr-priority

Overview Use this command to set the Designated Router priority value.
Use the no variant of this command to disable this function.
Syntax ipv6 pim dr-priority
no ipv6 pim dr-priority [<priority>]
Default The default value is 1. The negated form of this command restores the value to the
default.
Mode Interface Configuration for a VLAN interface.
Examples To set the Designated Router priority value to 11234 for the VLAN interface vlan2,
apply the commands as shown below:
awplus#
awplus(config)#
awplus(config)#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
To disable the Designated Router priority value for the VLAN interface vlan2, apply
the commands as shown below:
awplus#
awplus(config)#
awplus(config-if)#
Related ipv6 pim ignore-rp-set-priority
commands
C613-50103-01 REV A
Parameter Description
<priority>
<0-4294967294> Specify the Designated Router priority value. Note
that a higher value has a higher preference or higher priority.
configure terminal
ipv6 forwarding
ipv6 multicast-routing
interface vlan2
configure terminal
interface vlan2
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
<priority>
ipv6 enable
ipv6 pim dr-priority 11234
no ipv6 pim dr-priority
1277