Ipv6 Pim Crp-Cisco-Prefix - Allied Telesis x310-26FT Command Reference Manual

PIM-SM 6 C
V OMMANDS
6 - -
IPV PIM CRP CISCO PREFIX

ipv6 pim crp-cisco-prefix

Overview Use this command to interoperate with Cisco devices that conform to an earlier
draft standard. Some Cisco devices might not accept candidate RPs with a group
prefix number of zero. Note that the latest BSR specification prohibits sending RP
advertisements with prefix 0.
Use the no variant of this command to revert to the default settings.
ipv6 pim crp-cisco-prefix
Syntax
no ipv6 pim crp-cisco-prefix
Mode Global Configuration
Usage Cisco's BSR code does not conform to the latest BSR draft, it does not accept
candidate RPs with a group prefix number of zero. To make the candidate RP work
with a Cisco BSR, use the ipv6 pim crp-cisco-prefix command when
interoperating with older versions of Cisco IOS.
Example awplus#
awplus(config)#
awplus(config)#
awplus(config)#
awplus#
awplus(config)#
Related ipv6 pim rp-candidate
commands
C613-50103-01 REV A
configure terminal
ipv6 forwarding
ipv6 multicast-routing
ipv6 pim crp-cisco-prefix
configure terminal
no ipv6 pim crp-cisco-prefix
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
1276