Auth Reauthentication - Allied Telesis x310-26FT Command Reference Manual

A C
UTHENTICATION OMMANDS

AUTH REAUTHENTICATION

auth reauthentication
Overview This command enables re-authentication on the interface specified in the Interface
mode, which may be a static channel group (or static aggregator) or a dynamic (or
LACP) channel group or a switch port.
Use the no variant of this command to disables reauthentication on the interface.
Syntax auth reauthentication
no auth reauthentication
Default Reauthentication of port authentication is disabled by default.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port; or Authentication Profile mode.
To enable reauthentication on interface port1.0.2, use the following
Examples
commands:
awplus#
awplus(config)#
awplus(config-if)#
To disable reauthentication on interface port1.0.2, use the following
commands:
awplus#
awplus(config)#
awplus(config-if)#
To enable reauthentication on authentication profile 'student', use the commands:
awplus#
awplus(config)#
awplus(config-auth-profile)#
To disable reauthentication on authentication profile 'student', use the
commands:
awplus#
awplus(config)#
awplus(config-auth-profile)#
Related auth profile (Global Configuration)
Commands
show dot1x
show dot1x interface
show running-config
C613-50103-01 REV A
configure terminal
interface port1.0.2
auth reauthentication
configure terminal
interface port1.0.2
no auth reauthentication
configure terminal
auth profile student
configure terminal
auth profile student
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
auth reauthentication
no auth reauthentication
1606