Table of Contents
Advertisement
PIM-SM C
OMMANDS
IP PIM SSM
ip pim ssm
Overview
Use this command to define the Source Specific Multicast (SSM) range of IP
multicast addresses. The default keyword defines the SSM range as 232/8.
To define the SSM range to be other than the default, use the access-list parameter
option.
Use the no variant of this command to disable the SSM range.
ip pim ssm default
Syntax
ip pim ssm range {<access-list>|<named-access-list>}
no ip pim ssm
Default
By default, the command is disabled.
Mode
Global Configuration
Usage
When an SSM range of IP multicast addresses is defined by the ip pim ssm
command, the no (*,G) or (S,G,rpt) state will be initiated for groups in the SSM
range.
The messages corresponding to these states will not be accepted or originated in
the SSM range.
Examples
The following commands show how to configure SSM service for the IP address
range defined by access list 10:
awplus#
awplus(config)#
awplus(config)#
The following commands show how to set PIM-SSM as default:
awplus#
awplus(config)#
The following commands show how to disable PIM-SSM:
awplus#
awplus(config)#
C613-50103-01 REV A
Parameter
<access-list>
<named-access-list> Named Standard Access List.
configure terminal
access-list 10 permit 225.1.1.1
ip pim ssm range 10
configure terminal
ip pim ssm default
configure terminal
no ip pim ssm
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
<1-99> Simple access-list.
1242
Advertisement
Table of Contents
