Default-Metric (Ospf) - Allied Telesis x310-26FT Command Reference Manual

OSPF C
OMMANDS
- (OSPF)
DEFAULT METRIC

default-metric (OSPF)

Overview This command sets default metric values for the OSPF routing protocol.
The no variant of this command returns OSPF to using built-in, automatic metric
translations, as appropriate for each routing protocol.
Syntax default-metric <1-16777214>
no default-metric [<1-16777214>]
Mode Router Configuration
Usage A default metric facilitates redistributing routes even with incompatible metrics. If
the metrics do not convert, the default metric provides an alternative and enables
the redistribution to continue. The effect of this command is that OSPF will use the
same metric value for all redistributed routes. Use this command in conjunction
with the
Examples awplus#
awplus(config)#
awplus(config-router)#
awplus#
awplus(config)#
awplus(config-router)#
Related redistribute (OSPF)
commands
C613-50103-01 REV A
Parameter Description
<1-16777214>
Default metric value appropriate for the specified routing protocol.
redistribute (OSPF)
configure terminal
router ospf 100
configure terminal
router ospf 100
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
command.
default-metric 100
no default-metric
889