(Ipv6 Access-List Extended Ip Protocol Filter) - Allied Telesis x310-26FT Command Reference Manual

IP 6 S A C
V OFTWARE CCESS ONTROL
( 6 - IP
IPV ACCESS LIST EXTENDED

(ipv6 access-list extended IP protocol filter)

Overview Use this ACL filter to add a filter entry for an IPv6 source and destination address
and prefix, with or without an IP protocol specified, to the current extended IPv6
access-list. If a sequence is specified, the new entry is inserted at the specified
location. Otherwise, the new entry is added at the end of the access-list.
The no variant of this command removes a filter entry for an IPv6 source and
destination address and prefix, with or without an IP protocol filter entry, from the
current extended IPv6 access-list. You can specify the ACL filter entry by entering
either its sequence number, or its filter entry profile.
[<sequence-number>] {deny|permit} {ip|any|proto <ip-protocol>}
Syntax [ip|proto]
{<ipv6-source-address/prefix>|any}
{<ipv6-destination-address/prefix>|any} [log]
no {deny|permit} {ip|any|proto <ip-protocol>}
{<ipv6-source-address/prefix>|any}
{<ipv6-destination-address/prefix>|any} [log]
no [<sequence-number>]
Parameter
<sequence-number>
deny
permit
ip
any
proto <ip-protocol>
<ipv6-source-
address/prefix>
any
<ipv6- destination-
address/prefix>
any
log
C613-50103-01 REV A
L (ACL) C
IST OMMANDS
)
PROTOCOL FILTER
Description
<1-65535>
The sequence number for the filter entry of the selected access control list.
Specifies the packets to reject.
Specifies the packets to accept.
IP packet.
Any packet.
<1-255>
Specify IP protocol number, as defined by IANA (Internet Assigned Numbers
Authority www.iana.org/assignments/protocol-numbers)
See below for a list of IP protocol numbers and their descriptions.
IPv6 source address, or local address.
The IPv6 address uses the format X:X::X:X/Prefix-Length. The prefix-length is
usually set between 0 and 64.
Any source address or local address.
IPv6 destination address, or local address.
The IPv6 address uses the format X:X::X:X/Prefix-Length. The prefix-length is
usually set between 0 and 64.
Any destination address or remote address.
Log the results.
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
1468