Ipv6 Pim Cisco-Register-Checksum Group-List - Allied Telesis x310-26FT Command Reference Manual

PIM-SM 6 C
V OMMANDS
6 - -
IPV PIM CISCO REGISTER CHECKSUM GROUP

ipv6 pim cisco-register-checksum group-list

Overview Use this command to configure the option to calculate the Register Checksum
over the whole packet on multicast groups as specified by the software IPv6
access-list. This command is used to inter-operate with older Cisco IOS versions.
Use the no variant of this command to revert to default settings.
Syntax ipv6 pim cisco-register-checksum group-list <IPv6-access-list>
no ipv6 pim cisco-register-checksum group-list
<IPv6-access-list>
Mode Global Configuration
Default This command is disabled by default. By default, Register Checksum is calculated
only over the header.
awplus#
Example
awplus(config)#
awplus(config)#
awplus(config)#
awplus(config)#
ff0x::db8:0:0/96
C613-50103-01 REV A
-
LIST
Parameter
<IPv6-access-list>
configure terminal
ipv6 forwarding
ipv6 multicast-routing
ipv6 pim cisco-register-checksum group-list G1
ipv6 access-list standard G1 permit
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
Optional. Specify a Standard or Extended software IPv6
access list.
See IPv6 Software Access Control List (ACL) Commands
supported IPv6 ACLs.
Use this parameter to configure the option to calculate the
Register Checksum over the whole packet on multicast
groups as specified by an IPv6 access list entered after this
command.
for
1275