Ipv6 Pim Rp-Address - Allied Telesis x310-26FT Command Reference Manual

PIM-SM 6 C
V OMMANDS
6 -
IPV PIM RP ADDRESS

ipv6 pim rp-address

Overview Use this command to statically configure RP (Rendezvous Point) address for IPv6
multicast groups.
Use the no variant of this command to remove a statically configured RP
(Rendezvous Point) address for IPv6 multicast groups.
Syntax ipv6 pimv6 rp-address <IPv6-address> [<IPv6-access-list>]
[override]
no ipv6 pim rp-address <IPv6-address> [<IPv6-access-list>]
[override]
Mode Global Configuration
Usage The AlliedWare Plus™ PIM-SMv6 implementation supports multiple static RPs. It
also supports usage of static-RP and BSR mechanism simultaneously. The ipv6 pim
rp-address command is used to statically configure the RP address for IPv6
multicast groups.
You need to understand the following information before using this command.
If the RP-address that is configured by the BSR, and the RP-address that is
configured statically, are both available for a group range, then the RP-address
configured through BSR is chosen over the statically configured RP-address.
A single static-RP can be configured for multiple group ranges using software IPv6
access- lists (ACLs). However, configuring multiple static RPs (using ipv6 pim
rp-address command) with the same RP address is not allowed. The static-RP can
either be configured for the whole multicast group range ff00::/8 (without
using IPv6 ACLs) or for specific group ranges (when using IPv6 ACLs).
For example, configuring ipv6 pim rp-address 3ffe:10:10:5::153 will configure
static-RP 3ffe:10:10:5::153 for the default group range ff00::/8.
Configuring ipv6 pim rp-address 3ffee:20:20:5::153 grp-list will configure
static-RP 3ffe:20:20:5::153 for all the group ranges represented by permit
filters in the defined named grp-list ACL.
If multiple static-RPs are available for a group range, then one with the highest IPv6
address is chosen.
C613-50103-01 REV A
Parameter
<IPv6-address>
<IPv6-access-list> Specify a Standard or an Extended software IPv6 access-list
override
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
Specify the IPv6 address of the Rendezvous Point, entered
in the form X:X::X:X.
name.
See IPv6 Software Access Control List (ACL) Commands
supported IPv6 ACLs.
Specify this optional parameter keyword to enable any
statically defined RPs to override dynamically learned RPs.
for
1289