Radius-Server Retransmit - Allied Telesis x310-26FT Command Reference Manual

RADIUS C
OMMANDS
-
RADIUS SERVER RETRANSMIT

radius-server retransmit

Overview This command sets the retransmit counter to use RADIUS authentication on the
device. This command specifies how many times the device transmits each
RADIUS request to the RADIUS server before giving up.
This command configures the retransmit parameter for RADIUS servers globally.
If the retransmit parameter is not specified for a RADIUS server by the
radius-server host command then the global configuration set by this command
is used for the server instead.
Use the no variant of this command to reset the re-transmit counter to the default
(3).
radius-server retransmit <retries>
Syntax
no radius-server retransmit
Default The default RADIUS retransmit count on the device is 3.
Mode Global Configuration
Examples To set the RADIUS retransmit count to 1, use the following commands:
awplus#
awplus(config)#
To set the RADIUS retransmit count to the default (3), use the following
commands:
awplus#
awplus(config)#
To configure the RADIUS retransmit count globally with 5, use the following
commands:
awplus#
awplus(config)#
To disable retransmission of requests to a RADIUS server, use the following
commands:
awplus#
awplus(config)#
C613-50103-01 REV A
Parameter Description
<retries>
RADIUS server retries in the range <0-100>.
The number of times a request is resent to a RADIUS server that
does not respond, before the server is considered dead and the
next server is tried. If no retransmit value is specified for a
particular RADIUS server using the radius-server host
command, this global value is used.
configure terminal
radius-server retransmit 1
configure terminal
no radius-server retransmit
configure terminal
radius-server retransmit 5
configure terminal
radius-server retransmit 0
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
1755