Ipv6 Mld Version - Allied Telesis x310-26FT Command Reference Manual

MLD MLD S C
AND NOOPING OMMANDS
6
IPV MLD VERSION

ipv6 mld version

Overview Use this command to set the current MLD protocol version on an interface.
Use the no variant of this command to return to the default version on an interface.
Syntax ipv6 mld version <version>
no ipv6 mld version
Default The default MLD protocol version number is 2.
Mode Interface Configuration for a VLAN interface.
Usage This command applies to interfaces configured for MLD Layer-3 multicast
protocols and MLD Snooping. Note this command is intended for use where there
is another querier (when there is another device with MLD enabled) on the same
link that can only operate with MLD version 1. Otherwise, the default MLD version
2 is recommended for performance.
awplus#
Example
awplus(config)#
awplus(config)#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
C613-50103-01 REV A
Parameter Description
<version>
MLD protocol version number. Valid version numbers are 1 and 2
configure terminal
ipv6 forwarding
ipv6 multicast-routing
interface vlan2
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ipv6 enable
ipv6 mld version 1
1169