Table of Contents
Advertisement
PIM-SM C
OMMANDS
-
IP PIM SPARSE
MODE PASSIVE
ip pim sparse-mode passive
Overview
Use this command to enable and disable passive mode operation for local
members on the VLAN interface.
Use the no variant of this command to disable passive mode operation for local
members on the VLAN interface.
Syntax
ip pim sparse-mode passive
no ip pim sparse-mode passive
Mode
Interface Configuration for a VLAN interface.
Usage
Passive mode essentially stops PIM transactions on the interface, allowing only
IGMP mechanism to be active. To turn off passive mode, use the no ip pim
sparse-mode passive or the
activities on the VLAN interface, use the no ip pim sparse-mode command.
Examples
awplus#
awplus(config)#
awplus(config-if)#
awplus#
awplus(config)#
awplus(config-if)#
C613-50103-01 REV A
ip pim sparse-mode
configure terminal
interface vlan2
ip pim sparse-mode passive
configure terminal
interface vlan2
no ip pim sparse-mode passive
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
command. To turn off PIM
1239
Advertisement
Table of Contents
