Ipv6 Mld Robustness-Variable - Allied Telesis x310-26FT Command Reference Manual

MLD MLD S C
AND NOOPING OMMANDS
6 -
IPV MLD ROBUSTNESS VARIABLE

ipv6 mld robustness-variable

Overview Use this command to change the robustness variable value on an interface.
Use the no variant of this command to return to the default on an interface.
Syntax ipv6 mld robustness-variable <value>
no ipv6 mld robustness-variable
Default The default robustness variable value is 2.
Mode Interface Configuration for a specified VLAN interface or a range of VLAN
interfaces.
Usage This command applies to interfaces configured for MLD Layer-3 multicast
protocols.
Example awplus#
awplus(config)#
awplus(config)#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
C613-50103-01 REV A
Parameter Description
<value> Valid values are from 1 to 7.
configure terminal
ipv6 forwarding
ipv6 multicast-routing
interface vlan2
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ipv6 enable
ipv6 mld robustness-variable 3
1156