Distribute-List (Ospf) - Allied Telesis x310-26FT Command Reference Manual

OSPF C
OMMANDS
- (OSPF)
DISTRIBUTE LIST

distribute-list (OSPF)

Overview Use this command to apply filtering to the transfer of routing information between
OSPF and the IP route table. You can apply filtering in either direction, from OSPF
to the IP route table using an in distribute-list, or from the IP route table to OSPF
using an ou t distribute-list.
The effect of an in filter is that some route information that OSPF has learned from
LSA updates will not be installed into the IP route table. The effect of an out filter
is that some route information that could be redistributed to OSPF will not be
redistributed to OSPF. See the Usage section below for the distinction between
the in and out distribute-lists.
The entities that are used to perform filtering are ACLs or route-maps, which match
on certain attributes in the routes that are being transferred.
For information about ACLs and route maps, see the
Configuration Guide
Guide.
The no variant of this command removes the configured distribute-list command
entry.
Syntax distribute-list {<access-list-name>|route-map
<route-map-name>} in
no distribute-list <access-list-name> in
Mode Router Configuration
Usage There are in and out distribute-lists, which carry out different route filtering
activities:
•
C613-50103-01 REV A
and the
Parameter
<access-list-name>
in
out
<route-map-name>
connected
rip
static
The in distribute list is applied to the process of installing OSPF routes into
the IP route table. The SPF calculation generate a set of routes calculated
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Route Map Feature Overview and Configuration
Description
Specifies the name of the access list. The access list defines
which networks are received and which are suppressed.
Indicates that this applies to incoming advertised routes.
Indicates that this applies to outgoing advertised routes.
The name of the route-map that the distribute-list applies.
This defines which networks are installed in the IP route
table and which networks are filtered from the IP route
table.
Specify the redistribution of connected routes.
Specify the redistribution of RIP routes.
Specify the redistribution of static routes.
ACL Feature Overview and
892