Ip Pim Hello-Interval (Pim-Sm) - Allied Telesis x310-26FT Command Reference Manual

PIM-SM C
OMMANDS
- (PIM-SM)
IP PIM HELLO INTERVAL

ip pim hello-interval (PIM-SM)

Overview This command configures a hello-interval value.
Use the no variant of this command to reset the hello-interval to the default.
Syntax ip pim hello-interval <interval>
no ip pim hello-interval
Default The default hello-interval value is 30 seconds. The default is restored using the
negated form of this command.
Mode Interface Configuration for a VLAN interface.
Usage When the hello interval is configured, and the hello holdtime is not configured, or
when the configured hello-holdtime value is less than the new hello-interval value;
the holdtime value is modified to the (3.5 * hello interval). Otherwise, the
hello-holdtime value is the configured value.
awplus#
Example
awplus(config)#
awplus(config-if)#
C613-50103-01 REV A
Parameter Description
<interval>
<1-65535> The value in seconds (no fractional seconds accepted).
configure terminal
interface vlan2
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ip pim hello-interval 123
1226