Ipv6 Pim Hello-Holdtime - Allied Telesis x310-26FT Command Reference Manual

PIM-SM 6 C
V OMMANDS
6 -
IPV PIM HELLO HOLDTIME

ipv6 pim hello-holdtime

Overview This command configures a hello-holdtime value. You cannot configure a
hello-holdtime value that is less than the current hello-interval.
Use the no variant of this command to return it to its default of 3.5 * the current
hello-interval.
Syntax ipv6 pim hello-holdtime <holdtime>
no ipv6 pim hello-holdtime
Default The default hello-holdtime value is 3.5 * the current hello-interval. The default
hello- holdtime is restored using the negated form of this command.
Mode Interface Configuration for a VLAN interface.
Usage Each time the hello interval is updated, the hello holdtime is also updated,
according to the following rules:
If the hello holdtime is not configured; or if the hello holdtime is configured and
less than the current hello-interval value, it is modified to the (3.5 * hello interval).
Otherwise, it retains the configured value.
Examples awplus#
awplus(config)#
awplus(config)#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
C613-50103-01 REV A
Parameter Description
<holdtime>
<1-65535>
The holdtime value in seconds (no fractional seconds are accepted).
configure terminal
ipv6 forwarding
ipv6 multicast-routing
interface vlan2
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ipv6 enable
ipv6 pim hello-holdtime 123
1280