Match Eth-Format Protocol - Allied Telesis x310-26FT Command Reference Manual

Q S C
O OMMANDS
-
MATCH ETH FORMAT PROTOCOL

match eth-format protocol

Overview This command sets the Ethernet format and the protocol for a class-map to match
on.
Select one Layer 2 format and one Layer 3 protocol when you issue this command.
Use the no variant of this command to remove the configured Ethernet format and
protocol from a class-map.
match eth-format <layer-two-format> protocol
Syntax
<layer-three-protocol>
no match eth-format protocol
C613-50103-01 REV A
Parameter
<layer-two-formats>
802dot2-tagged
802dot2-untagged 802.2 Untagged Packets (enter the parameter name).
ethii-tagged
ethii-untagged
ethii-any
netwareraw-
tagged
netwareraw-
untagged
snap-tagged
snap-untagged
<layer-three-protocols>
<word>
any
sna-path-control Protocol Number 04 (enter the parameter name or its
proway-lan
eia-rs Protocol
proway Protocol
ipx-802dot2
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
802.2 Tagged Packets (enter the parameter name).
EthII Tagged Packets (enter the parameter name).
EthII Untagged Packets (enter the parameter name).
EthII Tagged or Untagged Packets (enter the parameter
name).
Netware Raw Tagged Packets (enter the parameter
name).
Netware Raw Untagged Packets (enter the parameter
name).
SNAP Tagged Packets (enter the parameter name).
SNAP Untagged Packets (enter the parameter name).
A Valid Protocol Number in hexidecimal.
Note that the parameter "any" is only valid when used
with the netwarerawtagged and netwarerawuntagged
protocol options.
number).
Protocol Number 0E (enter the parameter name or its
number).
Number 4E (enter the parameter name or its number).
Number 8E (enter the parameter name or its number).
Protocol Number E0 (enter the parameter name or its
number).
1495