Neighbor (Ipv6 Ripng) - Allied Telesis x310-26FT Command Reference Manual

RIP IP 6 C
NG FOR V OMMANDS
(IP 6 RIP )
NEIGHBOR V NG

neighbor (IPv6 RIPng)

Overview Use this command to specify a neighbor router.
Use the no variant of this command to disable the specific router.
Syntax neighbor <ipv6-link-local-addr> <interface>
no neighbor <ipv6-link-local-addr> <interface>
Mode Router Configuration
Usage Use this command to exchange non broadcast routing information. It can be used
multiple times for additional neighbors.
The
an interface. Use the neighbor command in conjunction with the
passive-interface (IPv6 RIPng)
neighbors.
awplus#
Examples
awplus(config)#
awplus(config-router)#
awplus#
awplus(config)#
awplus(config-router)#
Related passive-interface (IPv6 RIPng)
Commands
C613-50103-01 REV A
Parameter
<ipv6-link-local-addr> Specify the link-local IPv6 address (in the format
<interface>
passive-interface (IPv6 RIPng)
configure terminal
router ipv6 rip
configure terminal
router ipv6 rip
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
X:X::X:X) of a neighboring router to exchange routing
information with.
The interface. For instance: vlan2.
command disables sending routing updates on
command to send routing updates to specific
neighbor 2001:db8:1::1 vlan2
no neighbor 2001:db8:1::1 vlan2
846