Ip Igmp Last-Member-Query-Count - Allied Telesis x310-26FT Command Reference Manual

IGMP IGMP S C
AND NOOPING OMMANDS
- - -
IP IGMP LAST MEMBER QUERY COUNT

ip igmp last-member-query-count

Overview Use this command to set the last-member query-count value for an interface.
Use the no variant of this command to return to the default on an interface.
Syntax ip igmp last-member-query-count <2-7>
no ip igmp last-member-query-count
Default The default last member query count value is 2.
Mode Interface Configuration for a VLAN interface.
Usage This command applies to VLAN interfaces configured for IGMP, IGMP Snooping, or
IGMP Proxy.
Example To set the last-member query-count to 3 on vlan2, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
Related ip igmp last-member-query-interval
Commands
ip igmp startup-query-count
show ip igmp interface
show running-config
C613-50103-01 REV A
Parameter Description
<2-7>
Last member query count value.
configure terminal
interface vlan2
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ip igmp last-member-query-count 3
1091