Offset-List (Ipv6 Ripng) - Allied Telesis x310-26FT Command Reference Manual

RIP IP 6 C
NG FOR V OMMANDS
- (IP 6 RIP )
OFFSET LIST V NG

offset-list (IPv6 RIPng)

Overview Use this command to add an offset to in and out metrics to routes learned through
RIPng.
Use the no variant of this command to remove an offset list.
Syntax offset-list {<access-list-number>|<access-list-name>} {in|out}
<offset> [<interface>]
no offset-list {<access-list-number>|<access-list-name>}
{in|out} <offset> [<interface>]
Default The default offset value is the metric value of the interface over which the updates
are being exchanged.
Mode Router Configuration
Usage Use this command to specify the offset value that is added to the routing metric.
When the networks match the access list the offset is applied to the metrics. No
change occurs if the offset value is zero.
Example In this example the router examines the RIPng updates being sent out from
interface vlan2 and adds 8 hops to the routes matching the ip addresses
specified in the access list 2.
awplus#
awplus(config)#
awplus(config-router)#
C613-50103-01 REV A
Parameter
<access-list-number>
<access-list-name>
in
out
<offset>
<interface>
configure terminal
router ipv6 rip
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
Specify an access-list number to apply to an offset-list.
Specify and access-list name to apply to an offset-list.
Indicates the access-list will be used for metrics of
incoming advertised routes
Indicates the access-list will be used for metrics of
outgoing advertised routes
<0-16> Specifies that the offset is used for metrics of
networks matching the access-list
The interface to match. For instance: vlan2.
offset-list mylist in 8 vlan2
847