Mls Qos Map Cos-Queue To - Allied Telesis x310-26FT Command Reference Manual

Q S C
O OMMANDS
-
MLS QOS MAP COS QUEUE TO

mls qos map cos-queue to

Overview Use this command to set the default CoS to egress queue mapping. This is the
default queue mapping for packets that do not get assigned an egress queue via
any other QoS functionality.
Use the no variant of this command to reset the cos-queue map back to its default
setting. The default mappings for this command are:
mls qos map cos-queue <cos-priority> to <queue-number>
Syntax
no mls qos map cos-queue
Mode Global Configuration
To map CoS 2 to queue 0, use the command:
Examples
awplus#
awplus(config)#
To set the cos-queue map back to its defaults, use the command:
awplus#
awplus(config)#
Related show mls qos interface
Commands
C613-50103-01 REV A
CoS Priority :
-----------------------------------
CoS QUEUE:
Parameter Description
<cos-priority>
CoS priority value. Can take a value between 0 and 7.
<queue-number>
Queue number. Can take a value between 0 and 7.
configure terminal
mls qos map cos-queue 2 to 0
configure terminal
no mls qos map cos-queue
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
0 1 2 3 4 5 6 7
2 0 1 3 4 5 6 7
1506