Table of Contents
Advertisement
R
M
C
OUTE
AP
OMMANDS
6
MATCH IPV
ADDRESS
match ipv6 address
Overview
Use this command to specify the match address of route.
Use the no variant of this command to remove the match ipv6 address entry.
Syntax
match ipv6 address {<access-list-name>|prefix-list
<prefix-listname>}
no match ipv6 address [<access-list-name>|prefix-list
<prefix-listname>]
Mode
Route-map Configuration
Usage
The match ipv6 address <access-list> command specifies the IPv6 address to be
matched. If there is a match for the specified IPv6 address, and permitis specified,
the route is redistributed or controlled as specified by the set action. If the match
criteria are met, and deny is specified, the route is not redistributed or controlled.
If the match criteria are not met, the route is neither accepted nor forwarded,
irrespective of permit or deny specifications.
The match ipv6 address prefix-list command specifies the entries of prefix-lists
to be matched. If there is a match for the specified prefix-list entries, and permit
is specified, the route is redistributed or controlled as specified by the set action. If
the match criteria are met, and deny is specified, the route is not redistributed or
controlled. If the match criteria are not met, the route is neither accepted nor
forwarded, irrespective of permit or deny specifications.
awplus#
Examples
awplus(config)#
awplus(config-route-map)#
awplus#
awplus(config)#
awplus(config-route-map)#
C613-50103-01 REV A
Parameter
<access-list-name>
<prefix-listname>
configure terminal
route-map rmap1 deny 1
configure terminal
route-map rmap1 permit 3
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
The name of the IPv6 access list that specifies criteria for
the addresses to match.
Valid only with RIPng.
The name of the IPv6 prefix list that specifies criteria for
the addresses to be matched.
Valid only with RIPng.
match ipv6 address rmap1
match ipv6 address prefix-list mylist
1068
Advertisement
Table of Contents
