Restart Ipv6 Ospf Graceful - Allied Telesis x310-26FT Command Reference Manual

OSPF 3 IP 6 C
V FOR V OMMANDS
6
RESTART IPV OSPF GRACEFUL

restart ipv6 ospf graceful

Overview Use this command to force the OSPFv3 process to restart. You may optionally
specify a grace-period value. If a grace-period is not specified then a default value
of 120 seconds is applied.
You should specify a grace-period value of 120 seconds or more. Low grace-period
values may cause the graceful restart process on neighboring routers to terminate
with routes missing.
restart ipv6 ospf graceful [grace-period <1-1800>]
Syntax
Default The default OSPF grace-period is 120 seconds.
Mode Privileged Exec
Usage After this command is executed, the OSPFv3 process immediately shuts down. It
notifies the system that OSPF has performed a graceful shutdown. Routes installed
by OSPF are preserved until the grace-period expires.
When a restart ospf graceful command is issued, the OSPF configuration is
reloaded from the last saved configuration. Ensure you first enter the
running-config startup- config
Example To restart OSPFv3, use the following commands:
awplus#
awplus#
To apply the default grace-period (120 seconds), use the following commands:
awplus#
awplus#
C613-50103-01 REV A
Parameter Description
grace-period
Specify the grace period.
<1-1800>
The grace period in seconds.
copy running-config startup-config
restart ipv6 ospf graceful grace-period 200
copy running-config startup-config
restart ipv6 ospf graceful
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
command.
copy
1023