Match Metric - Allied Telesis x310-26FT Command Reference Manual

R M C
OUTE AP OMMANDS

MATCH METRIC

match metric
Overview Use this command to add a metric match clause to a route map entry. Specify the
metric value to match.
A route matches the route map if its metric matches the route map's metric.
Each entry of a route map can only match against one metric value in one metric
match clause. If the route map entry already has a metric match clause, entering
this command replaces that match clause with the new clause.
Use the no variant of this command to remove the metric match clause from the
route map entry.
Syntax match metric <metric>
no match metric [<metric>]
Mode Route-map Configuration
Usage This command is valid for:
•
•
To stop entry 3 of the route map called myroute from processing routes with a
Example
metric of 888999, use the commands:
awplus#
awplus(config)#
awplus(config-route-map)#
Related route-map
Commands
set metric
show route-map
C613-50103-01 REV A
Parameter Description
<metric>
<0-4294967295> Specifies the metric value.
OSPF routes
RIP routes.
configure terminal
route-map myroute permit 3
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
no match metric 888999
1069