Auth Radius Send Nas-Identifier - Allied Telesis x310-26FT Command Reference Manual

RADIUS C
OMMANDS
-
AUTH RADIUS SEND NAS IDENTIFIER

auth radius send nas-identifier

Overview Use this command to enable the device to include the NAS-Identifier(32) attribute
in RADIUS authentication requests.
Use the no variant of this command to stop including the NAS-Identifier attribute.
Syntax auth radius send nas-identifier [<name>|vlan-id]
no auth radius send nas-identifier
Mode Global Configuration
Example To use a user-defined identifier of NASID100 as the NAS-Identifier attribute, use the
commands:
awplus#
awplus(config)#
To use the VLAN ID as the NAS-Identifier attribute, use the commands:
awplus#
awplus(config)#
To stop sending the NAS-Identifier attribute, use the commands:
awplus#
awplus(config)#
Related auth radius send service-type
Commands
C613-50103-01 REV A
Parameter Description
<name>
Send this user-defined text as the NAS-Identifier. You can specify
up to 253 characters.
vlan-id
Send the VLAN ID of the authentication port as the NAS-Identifier.
This is the configured VLAN ID, not the dynamic VLAN ID or guest
VLAN ID.
configure terminal
auth radius send nas-identifier NASID100
configure terminal
auth radius send nas-identifier vlan-id
configure terminal
no auth radius send nas-identifier
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
1745