Show Auth Supplicant Interface - Allied Telesis x310-26FT Command Reference Manual

A C
UTHENTICATION OMMANDS

SHOW AUTH SUPPLICANT INTERFACE

show auth supplicant interface
Overview This command shows the supplicant (client device) state for the authentication
mode set for the interface, which may be a static channel (or static aggregator) or
a dynamic (or LACP) channel group or a switch port. Use the optional brief
parameter to show a summary of the supplicant state.
show auth-web supplicant interface <interface-list> [brief]
Syntax
Mode Privileged Exec
To display the authenticated supplicant on the interface port1.0.3, enter the
Examples
command:
awplus#
To display brief summary output for the authenticated supplicant, enter the
command:
awplus#
C613-50103-01 REV A
Parameter
<interface-list> The interfaces or ports to configure. An interface-list can be:
brief
show auth supplicant interface port1.0.3
show auth supplicant brief
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
• an interface (e.g. vlan2), a switch port (e.g. port1.0.6),
a static channel group (e.g. sa2) or a dynamic (LACP)
channel group (e.g. po2)
• a continuous range of interfaces, ports, static channel
groups or dynamic (LACP) channel groups separated by a
hyphen; e.g. vlan2-8, or port1.0.1-1.0.4, or sa1-2,
or po1-2
• a comma-separated list of the above; e.g.
port1.0.1,port1.0.4-1.0.6. Do not mix interface
types in a list
The specified interfaces must exist.
Brief summary of the supplicant state.
1691