Ip Pim Hello-Interval (Pim-Dm) - Allied Telesis x310-26FT Command Reference Manual

PIM-DM C
OMMANDS
- (PIM-DM)
IP PIM HELLO INTERVAL

ip pim hello-interval (PIM-DM)

Overview This command configures a PIM hello-interval value. The PIM hello-interval on a
VLAN interface is the period at which the router will transmit PIM hello messages
on that interface.
When the hello-interval is configured, and the hello-holdtime is not configured,
or when the configured hello-holdtime value is less than the new hello-interval
value; the hello-holdtime value is modified to 3.5 times the hello-interval value.
Otherwise, the hello-holdtime value is the configured value. The default is 30
seconds.
Use the no variant of this command to reset the hello-interval to the default.
ip pim hello-interval <interval>
Syntax
no ip pim hello-interval
Mode Interface Configuration for a VLAN interface.
awplus#
Example
awplus(config)#
awplus(config-if)#
C613-50103-01 REV A
Parameter Description
<interval>
<1-65535> The value in seconds (no fractional seconds accepted).
configure terminal
interface vlan2
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ip pim hello-interval 123
1336