Show Ip Pim Dense-Mode Interface - Allied Telesis x310-26FT Command Reference Manual

PIM-DM C
OMMANDS
-
SHOW IP PIM DENSE MODE INTERFACE

show ip pim dense-mode interface

Overview This command displays the PIM-DM interface information.
For information on filtering and saving command output, see the
with AlliedWare Plus" Feature Overview and Configuration
Syntax show ip pim dense-mode interface
Mode User Exec and Privileged Exec
Example To display information about the PIM-DM interfaces, use the command:
awplus#
Output
Table 1: Parameters in the output of the show ip pim dense-mode interface
C613-50103-01 REV A
show ip pim dense-mode interface
Total configured interfaces: 24
Total active interfaces:

Address Interface VIFIndex Ver/
192.168.1.53/24 vlan2
192.168.2.1 vlan3
...
Note that this screen has been edited to remove any additional 
interfaces.
command
Parameter
Total configured
interfaces
Maximum allowed
Total active
interfaces
Address
Interface
VIF Index
Ver/Mode
Nbr Count
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Maximum allowed: 32
22
Mode
0 v2/D
2 v2/D
Description
The number of configured PIM Dense Mode interfaces.
The maximum number of PIM Dense Mode interfaces that
can be configured.
The number of active PIM Dense Mode interfaces.
Primary PIM-DM address.
Name of the PIM-DM interface.
The Virtual Interface index of the VLAN.
PIM version/Dense mode.
Neighbor count of the PIM-DM interface.
"Getting Started
Guide.
Nbr
Count
2
0
1343