Area Default-Cost (Ipv6 Ospf) - Allied Telesis x310-26FT Command Reference Manual

OSPF 3 IP 6 C
V FOR V OMMANDS
- (IP 6 OSPF)
AREA DEFAULT COST V

area default-cost (IPv6 OSPF)

Overview This command specifies a cost for the default summary route sent into a stub area.
The no variant of this command removes the assigned default-route cost.
Syntax area <area-id> default-cost <0-16777215>
no area <area-id> default-cost
Mode Router Configuration
Usage The default-cost option provides the metric for the summary default route,
generated by the area border router, into the stub area. Use this option only on an
area border router that is attached to the stub area.
Example To set the default cost to 10 in area 1 for the OSPF process P2, use the commands:
awplus#
awplus(config)#
awplus(config-router)#
Related area stub (IPv6 OSPF)
Commands
C613-50103-01 REV A
Parameter Description
<area-id>
The OSPF area that you are specifying the summary route default-
cost for. This can be entered in either dotted decimal format or
normal decimal format. Use one of the following formats:
<ip-addr>
<0-4294967295>
For example, the values 0.0.1.2 and decimal 258 would both define
the same area-ID.
default-cost Indicates the cost for the default summary route used for a stub
area.
Default: 1
configure terminal
router ipv6 ospf P2
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
OSPF area-ID expressed in IPv4 address
format A.B.C.D.
OSPF area-ID expressed as a decimal number
within the range shown.
area 1 default-cost 10
972