Ip Pim Dense-Mode Passive - Allied Telesis x310-26FT Command Reference Manual

PIM-DM C
OMMANDS
-
IP PIM DENSE MODE PASSIVE

ip pim dense-mode passive

Overview This command enables PIM-DM passive mode operation from Interface mode on
the current VLAN interface.
The no variant of this command disables passive mode.
Syntax ip pim dense-mode passive
no ip pim dense-mode passive
Mode Interface Configuration for a VLAN interface.
Usage Configuring a VLAN interface as a passive PIM-DM interface indicates that the
VLAN interface is connected to a stub network (i.e. a network that does not contain
any PIM Routers). So, multicast streams that arrive on other PIM-DM interfaces can
be routed to hosts on the passive PIM-DM interface, but no PIM neighbor
relationships will be formed on the passive PIM-DM interface.
Example awplus#
awplus(config)#
awplus(config-if)#
C613-50103-01 REV A
configure terminal
interface vlan2
ip pim dense-mode passive
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
1333