Ipv6 Pim Ext-Srcs-Directly-Connected - Allied Telesis x310-26FT Command Reference Manual

PIM-SM 6 C
V OMMANDS
6 - - -
IPV PIM EXT SRCS DIRECTLY CONNECTED

ipv6 pim ext-srcs-directly-connected

Overview Use this command to configure PIM-SMv6 to treat all source traffic arriving on the
interface as though it was sent from a host directly connected to the interface.
Use the no variant of this command to configure PIM-SMv6 to treat only directly
connected sources as directly connected.
Syntax ipv6 pim ext-srcs-directly-connected
no ipv6 pim ext-srcs-directly-connected
Default The no variant of this command is the default behavior.
Mode Interface Configuration for a VLAN interface.
Example To configure PIM-SMv6 to treat all sources as directly connected for VLAN interface
vlan2, use the following commands:
awplus#
awplus(config)#
awplus(config)#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
To configure PIM-SMv6 to treat only directly connected sources as directly
connected for VLAN interface vlan2, use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
C613-50103-01 REV A
configure terminal
ipv6 forwarding
ipv6 multicast-routing
interface vlan2
ipv6 enable
ipv6 pim ext-srcs-directly-connected
configure terminal
interface vlan2
no ipv6 pim ext-srcs-directly-connected
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
1279