Ipv6 Pim Rp Embedded - Allied Telesis x310-26FT Command Reference Manual

PIM-SM 6 C
V OMMANDS
6
IPV PIM RP EMBEDDED

ipv6 pim rp embedded

Overview Use this command to configure and enable embedded RP (Rendezvous Point) in
PIM-SMv6.
This command only applies to the embedded RP group range ff7x::/12 and
fffx::/12.
Use the no variant of this command to disable embedded RP support. Since
embedded RP support is enabled by default, use the no variant of this command
to disable the default.
ipv6 pim rp embedded
Syntax
no ipv6 pim rp embedded
Mode Global Configuration
Default Embedded RP is enabled by default in the AlliedWare Plus implementation of
PIM-SMv6.
Examples The following example re-enables embedded RP support, the default state in
PIM-SMv6:
awplus#
awplus(config)#
awplus(config)#
awplus(config)#
The following example disables embedded RP support, which is enabled by
default in PIM-SMv6:
awplus#
awplus(config)#
C613-50103-01 REV A
configure terminal
ipv6 forwarding
ipv6 multicast-routing
ipv6 pim rp embedded
configure terminal
no ipv6 pim rp embedded
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
1293