Table of Contents
Advertisement
IGMP
IGMP S
C
AND
NOOPING
OMMANDS
IP IGMP SNOOPING MROUTER
ip igmp snooping mrouter
Overview
Use this command to statically configure the specified port as a multicast router
port for IGMP Snooping for an interface. This command applies to interfaces
configured for IGMP Snooping.
Use the no variant of this command to remove the static configuration of the port
as a multicast router port.
ip igmp snooping mrouter interface <port>
Syntax
no ip igmp snooping mrouter interface <port>
Mode
Interface Configuration for a VLAN interface.
Example
To configure port1.0.2 statically as a multicast router interface for vlan2, use the
commands:
awplus#
awplus(config)#
awplus(config-if)#
Related
show ip igmp snooping mrouter
Commands
C613-50103-01 REV A
Parameter
Description
<port>
The port may be a device port (e.g. port1.0.4), a static channel
group (e.g. sa3), or a dynamic (LACP) channel group (e.g. po4).
configure terminal
interface vlan2
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ip igmp snooping mrouter interface port1.0.2
1109
Advertisement
Table of Contents
