Route Map Commands; Introduction; Chapter 26: Route Map Commands - Allied Telesis x310-26FT Command Reference Manual

26

Introduction

Overview This chapter provides an alphabetical reference for route map commands. These
commands can be divided into the following categories:
•
•
•
Command List •
•
•
•
•
•
•
•
•
•
•
•
•
C613-50103-01 REV A
route-map command, used to create a route map and/or route map entry,
and to put you into route map mode
match commands, used to determine which routes the route map applies to
set commands, used to modify matching routes
"match interface" on page 1062
"match ip address" on page 1063
"match ip next-hop" on page 1066
"match ipv6 address" on page 1068
"match metric" on page 1069
"match route-type" on page 1070
"match tag" on page 1071
"route-map" on page 1072
"set ip next-hop (route
"set metric" on page 1075
"set metric-type" on page 1077
"set tag" on page 1078
"show route-map" on page 1079
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Route Map
Commands
map)" on page 1074
1061