Show Interface Access-Group - Allied Telesis x310-26FT Command Reference Manual

IP 4 H A C
V ARDWARE CCESS ONTROL
-
SHOW INTERFACE ACCESS GROUP

show interface access-group

Overview Use this command to display the access groups attached to a port. If an access
group is specified, then the output only includes the ports that the specified access
group is attached to. If no access group is specified then this command displays all
access groups that are attached to the ports that are specified with <port-list>.
Note that access group is the term given for an access-list when it is applied to an
interface.
NOTE
supported when the switch forms part of a VCStack.
show interface <port-list> access-group
Syntax
[<3000-3699>|<4000-4699>]
Mode User Exec and Privileged Exec
To show all access-lists attached to port1.0.1, use the command:
Example
awplus#
Output Figure 33-1: Example output from the show interface access-group command
Related access-group
Commands
C613-50103-01 REV A
L (ACL) C
IST OMMANDS
: This command will function on the switch in stand-alone mode, but is not
Parameter
<port-list>
access group
<3000-3699>
<4000-4699>
show interface port1.0.1 access-group
Interface port1.0.1
access-group 3000
access-group 3002
access-group 3001
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
Specify the ports to display information. A port-list can be
either:
• a switch port (e.g. port1.0.6) a static channel group (e.g.
sa2) or a dynamic (LACP) channel group (e.g. po2)
• a continuous range of ports separated by a hyphen, e.g.
port1.0.1-1.0.6 or port1.0.1-port1.0.6 or po1-po2
• a comma-separated list of ports and port ranges, e.g.
port1.0.1,port1.0.3-1.0.6. Do not mix switch ports, static
channel groups, and LACP channel groups in the same
list.
Select the access group whose details you want to show.
Specifies the Hardware IP access-list.
Specifies the Hardware MAC access-list.
1387