Table of Contents
Advertisement
IP
6 H
A
C
V
ARDWARE
CCESS
ONTROL
(
6
-
TCP UDP
IPV
ACCESS
LIST NAMED
(ipv6 access-list named TCP UDP filter)
Overview
Use this ACL filter to add a filter entry for an IPv6 source and destination address
and prefix, with TCP (Transmission Control Protocol) or UDP (User Datagram
Protocol) source and destination ports specified, to the current named IPv6
access-list.
If you specify a sequence number, the new entry is inserted at the specified
location. Otherwise, the new entry is added at the end of the access-list.
Note that specifying the send-to-cpu parameter could result in EPSR healthcheck
messages and other control packets being dropped.
The no variant of this command removes a filter entry for an IPv6 source and
destination address and prefix, with TCP or UDP source and destination ports
specified, from the current named IPv6 access-list. You can specify the filter entry
for removal by entering either its sequence number, or its filter entry profile.
[<sequence-number>]
Syntax
{deny|permit|send-to-cpu|send-to-mirror|copy-to-cpu|
copy-to-mirror} {tcp|udp}
{<ipv6-source-prefix/prefix-length>|
<ipv6-source-address> <ipv6-source-wildcard>|
host <ipv6-source-host>|any}
{eq <sourceport>|lt <sourceport>|gt <sourceport>|
ne <sourceport>|range <start-range> <end-range>]}
{<ipv6-destination-prefix/prefix-length>|
<ipv6-destination-address> <ipv6-destination-wildcard>|
host <ipv6-destination-host>|any}
{[eq <destport>|lt <destport>|gt <destport>|
ne <destport>|range <start-range> <end-range>]} [vlan <1-4094>]
no {deny|permit|send-to-cpu|send-to-mirror|copy-to-cpu|
copy-to-mirror} {tcp|udp}
{<ipv6-source-prefix/prefix-length>|
<ipv6-source-address> <ipv6-source-wildcard>|
host <ipv6-source-host>|any}
{eq <sourceport>|lt <sourceport>|gt <sourceport>|
ne <sourceport>|range <start-range> <end-range>]}
{<ipv6-destination-prefix/prefix-length>|
<ipv6-destination-address> <ipv6-destination-wildcard>|
host <ipv6-destination-host>|any}
{eq <destport>|lt <destport>|gt <destport>|
ne <destport>}|range <start-range> <end-range>} [vlan <1-4094>]
no <sequence-number>
C613-50103-01 REV A
L
(ACL) C
IST
OMMANDS
)
FILTER
Parameter
<sequence-number>
deny
permit
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
The sequence number for the filter entry of the
selected access control list, from 1 to 65535.
Specify packets to reject.
Specifies the packets to permit.
1451
Advertisement
Table of Contents
