Table of Contents
Advertisement
IGMP
IGMP S
C
AND
NOOPING
OMMANDS
-
IP IGMP ACCESS
GROUP
ip igmp access-group
Overview
This command adds an access control list to a VLAN interface configured for IGMP,
IGMP Snooping, or IGMP Proxy. The access control list is used to control and filter
the multicast groups learned on the VLAN interface.
The no variant of this command disables the access control filtering on the
interface.
ip igmp access-group {<access-list-number>|<access-list-name>}
Syntax
no ip igmp access-group
Default
By default there are no access lists configured on any interface.
Mode
Interface Configuration for a VLAN interface.
Usage
This command applies to VLAN interfaces configured for IGMP, IGMP Snooping, or
IGMP Proxy.
Example
In the following example, hosts serviced by VLAN interface vlan2 can only join the
group 225.2.2.2:
awplus#
awplus(config)#
awplus(config)#
awplus(config-if)#
C613-50103-01 REV A
Parameter
<access-list-number>
<access-list-name>
configure terminal
access-list 1 permit 225.2.2.2 0.0.0.0
interface vlan2
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
Standard IP access-list number, in the range <1-99>.
Standard IP access-list name.
ip igmp access-group 1
1088
Advertisement
Table of Contents
