Bandwidth - Allied Telesis x310-26FT Command Reference Manual

OSPF 3 IP 6 C
V FOR V OMMANDS

BANDWIDTH

bandwidth
Overview Use this command to specify the maximum bandwidth to be used for each VLAN
interface. The bandwidth value is in bits per second. OSPF uses this to calculate
metrics for the VLAN interface.
The no variant of this command removes any applied bandwidth value and
replaces it with a value equal to the lowest port speed within that VLAN.
bandwidth
Syntax
no bandwidth
Mode Interface Configuration for a VLAN interface.
Example To set the bandwidth on VLAN2 to be 1 Mbps, use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
Or
awplus(config-if)#
Related show running-config
Commands
show interface
C613-50103-01 REV A
<bandwidth-setting>
Parameter
<bandwidth-setting>
configure terminal
interface vlan2
access-list
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
Sets the bandwidth for the interface. Enter a value in
the range 1 to 10000000000 bits per second. Note that
to avoid entering many zeros, you can add k, m, or g to
internally add 3, 6 or 9 zeros to the number entered. For
example entering 1k is the same as entering 1000.
bandwidth 1000000
bandwidth 1m
988