(Access-List Extended Ip Filter) - Allied Telesis x310-26FT Command Reference Manual

IP 4 S A C
V OFTWARE CCESS ONTROL
( - IP
ACCESS LIST EXTENDED FILTER

(access-list extended IP filter)

Overview Use this ACL filter to add a new IP filter entry to the current extended access-list. If
the sequence number is specified, the new filter is inserted at the specified
location. Otherwise, the new filter is added at the end of the access-list.
The no variant of this command removes an IP filter entry from the current
extended access-list. You can specify the IP filter entry for removal by entering
either its sequence number (e.g. no 10), or by entering its IP filter profile without
specifying its sequence number.
Note that the sequence number can be found by running the
Software ACLs)
[<sequence-number>] {deny|permit} ip <source> <destination>
Syntax [ip]
no {deny|permit} ip <source> <destination>
no <sequence-number>
C613-50103-01 REV A
L (ACL) C
IST OMMANDS
)
command.
Parameter Description
<sequence-
<1-65535>
number>
The sequence number for the filter entry of the selected access
control list.
deny
Access-list rejects packets that match the source and destination
filtering specified with this command.
permit
Access-list permits packets that match the source and destination
filtering specified with this command.
<source>
The source address of the packets. You can specify a single host, a
subnet, or all sources. The following are the valid formats for
specifying the source:
any
host<ip-addr>
<ip-addr>
<reverse-mask>
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
show access-list (IPv4
Matches any source IP address.
Matches a single source host with the IP
address given by <ip-addr> in dotted
decimal notation.
Alternatively, enter an IPv4 address
followed by a reverse mask in dotted
decimal format. For example, enter
192.168.1.1 0.0.0.255.
1403