(Ipv6 Access-List Named Icmp Filter) - Allied Telesis x310-26FT Command Reference Manual

IP 6 H A C
V ARDWARE CCESS ONTROL
( 6 - ICMP
IPV ACCESS LIST NAMED

(ipv6 access-list named ICMP filter)

Overview Use this ACL filter to add a filter entry for an IPv6 source and destination address
and prefix, with ICMP (Internet Control Message Protocol) packets, to the current
named IPv6 access-list.
If you specify a sequence number, the new entry is inserted at the specified
location. Otherwise, the new entry is added at the end of the access-list.
Note that specifying the send-to-cpu parameter could result in EPSR healthcheck
messages and other control packets being dropped.
As an optional parameter, vlan can be matched for tagged (802.1q) packets.
The no variant of this command removes a filter entry for an IPv6 source and
destination address and prefix, with ICMP (Internet Control Message Protocol)
packets, from the current named IPv6 access-list. You can specify the filter entry for
removal by entering either its sequence number, or its filter entry profile.
NOTE
[<sequence-number>
Syntax
{deny|permit|send-to-cpu|send-to-mirror|copy-to-cpu|
copy-to-mirror} icmp 
{<ipv6-source-address/prefix-length>|
<ipv6-source-address> <ipv6-source-wildcard>|
host <ipv6-source-host>|any}
{<ipv6-destination-address/prefix-length>|
<ipv6-destination-addr> <ipv6-destination-wildcard>|
host <ipv6-destination-host-address>|any} 
[<icmp-type>] [vlan <1-4094>]
no [<sequence-number>]
{deny|permit|send-to-cpu|send-to-mirror|copy-to-cpu|
copy-to-mirror} icmp 
{<ipv6-source-address/prefix-length>|
<ipv6-source-address> <ipv6-source-wildcard>|
host <ipv6-source-host>|any}
{<ipv6-destination-address/prefix-length>|
<ipv6-destination-address> <ipv6-destination-wildcard>|
host <ipv6-destination-host-address>|any} 
[<icmp-type>] [vlan <1-4094>]
no [<sequence-number>]
C613-50103-01 REV A
L (ACL) C
IST OMMANDS
)
FILTER
: Hardware ACLs will permit access unless explicitly denied by an ACL action.
Parameter
<sequence-number>
deny
permit
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
The sequence number for the filter entry of the
selected access control list, from 1 to 65535.
Specifies the packets to reject.
Specifies the packets to permit.
1441