Table of Contents
Advertisement
PIM-SM C
OMMANDS
-
IP PIM BSR
CANDIDATE
ip pim bsr-candidate
Overview
Use this command to give the device the candidate BSR (Bootstrap Router) status
using the specified IP address mask of the interface.
Use the no variant of this command to withdraw the address of the interface from
being offered as a BSR candidate.
Syntax
ip pim bsr-candidate <interface> [<hash>] [<priority>]
no ip pim bsr-candidate [<interface>]
Mode
Global Configuration
Default
The default hash parameter value is 10 and the default priority parameter value is
64.
Examples
To set the BSR candidate to the VLAN interface vlan2, with the optional mask
length and BSR priority parameters, enter the commands shown below:
awplus#
awplus(config)#
To withdraw the address of vlan2 from being offered as a BSR candidate, enter:
awplus#
awplus(config)#
C613-50103-01 REV A
Parameter
Description
<interface>
The interface. For instance, vlan2.
<hash>
<0-32> configure hash mask length for RP selection. The default hash
value if you do not configure this parameter is 10.
<priority>
<0-255> configure priority for a BSR candidate. Note that you must
also specify the <hash> (mask length) when specifying the <priority>.
The default priority if you do not configure this parameter is 64.
configure terminal
ip pim bsr-candidate vlan2 20 30
configure terminal
no ip pim bsr-candidate vlan2
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
1218
Advertisement
Table of Contents
