Ipv6 Pim Accept-Register - Allied Telesis x310-26FT Command Reference Manual

PIM-SM 6 C
V OMMANDS
6 -
IPV PIM ACCEPT REGISTER

ipv6 pim accept-register

Overview Use this command to configure the ability to filter out multicast sources specified
by the given software IPv6 access-list at the Rendezvous Point (RP), so that the RP
will accept/refuse to perform the register mechanism for the packets sent by the
specified sources. By default, the RP accepts register packets from all multicast
sources.
Use the no variant of this command to revert to default.
ipv6 pim accept-register list{<access-list>}
Syntax
no ipv6 pim accept-register
Mode Global Configuration
awplus#
Example
awplus(config)#
awplus(config)#
awplus(config)#
awplus(config)#
2001:db8::/128
awplus#
awplus(config)#
C613-50103-01 REV A
Parameter Description
<access-list>
Specify a Standard or an Extended software IPv6 Access list.
See
supported IPv6 ACLs.
configure terminal
ipv6 forwarding
ipv6 multicast-routing
ipv6 pim accept-register list G2
ipv6 access-list standard G2 permit
configure terminal
no ipv6 pim accept-register
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IPv6 Software Access Control List (ACL) Commands for
1270