Dot1X Max-Reauth-Req - Allied Telesis x310-26FT Command Reference Manual

802.1X C
OMMANDS
1 - -
DOT X MAX REAUTH REQ

dot1x max-reauth-req

Overview This command sets the number of reauthentication attempts before an interface
is unauthorized.
The no variant of this command resets the reauthentication delay to the default.
Syntax dot1x max-reauth-req <1-10>
no dot1x max-reauth-req
Default The default maximum reauthentication attempts for interfaces using 802.1X port
authentication is two (2) reauthentication attempts, before an interface is
unauthorized.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port; or Authentication Profile mode.
Usage Use this command to set the maximum reauthentication attempts after failure.
Examples To configure the maximum number of reauthentication attempts for interface
port1.0.2 to a single (1) reauthentication request, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
To configure the maximum number of reauthentication attempts for interface
port1.0.2 to the default maximum number of two (2) reauthentication
attempts, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
To configure the maximum number of reauthentication attempts for
authentication profile 'student' to a single (1) reauthentication request, use the
commands:
awplus#
awplus(config)#
awplus(config-auth-profile)#
C613-50103-01 REV A
Parameter Description
<1-10>
Specify the maximum number of reauthentication attempts for
supplicants on an interface using 802.1X port authentication.
configure terminal
interface port1.0.2
configure terminal
interface port1.0.2
configure terminal
auth profile student
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
dot1x max-reauth-req 1
no dot1x max-reauth-req
dot1x max-reauth-req 1
1559