Remark-Map - Allied Telesis x310-26FT Command Reference Manual

Q S C
O OMMANDS
-
REMARK MAP

remark-map

Overview Use this command to configure the remark map. If a re-mark map is applied to a
class, and a policer is also applied to the same class, then:
•
•
The no variant of this command resets the remark map to its defaults. Specifying
the bandwidth class is optional. If no bandwidth class is specified, then all
bandwidth classes are reset to their defaults.
Syntax remark-map [bandwidth-class {green|yellow|red}] to {[new-dscp
<0-63>] [new-bandwidth-class {green|yellow|red}]}
no remark-map [bandwidth-class {green|yellow|red}] to
{[new-dscp <0-63>] [new-bandwidth-class {green|yellow|red}]}
Mode Policy Map Class Configuration
Examples To remark the policed green traffic to a new DSCP of 2 and a new bandwidth class
of yellow, use the commands:
awplus#
awplus(config)#
awplus(config-pmap)#
awplus(config-pmap-c)#
new-dscp 2 new-bandwidth-class yellow
C613-50103-01 REV A
green and yellow traffic will all be acted upon by the remark-map, and
red traffic will be either dropped or acted upon by the remark-map,
depending on whether the policer action is set to drop-red or
remark-transmit.
Parameter
bandwidth-class
green
yellow
red
new-dscp
<0-63>
new-bandwidth-class
green
yellow
red
configure terminal
policy-map pmap1
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
Specify the bandwidth class of packets to remark.
Remark green packets.
Remark yellow packets.
Remark red packets.
Specify the new DSCP value.
The DSCP value.
Specify the new bandwidth class.
Remark the packet green.
Remark the packet yellow.
Remark the packet red.
class cmap1
remark-map bandwidth-class green to
1516