PIM-SM
6 C
V
OMMANDS
6
-
SHOW IPV
PIM SPARSE
MODE RP NEXTHOP
show ipv6 pim sparse-mode rp nexthop
Overview
Use this command to display the RP (Rendezvous Point) next hop information used
by PIM-SMv6.
For information on filtering and saving command output, see the
with AlliedWare Plus" Feature Overview and Configuration
Syntax
show ipv6 pim sparse-mode rp nexthop <RP-group-addr>
Mode
User Exec and Privileged Exec
Example
awplus#
Figure 31-14: Example output from the show ipv6 pim sparse-mode rp
awplus#show ipv6 pim sparse-mode rp nexthop 3ffe:10:10:5::153
Flags: N = New, R = RP, S = Source, U = Unreachable
Destination
_____________________________________________________________________________________
3ffe:10:10:5::153
Table 3: Parameters in output of the show ipv6 pim sparse-mode rp nexthop
C613-50103-01 REV A
Parameter
<RP-group-addr>
show ipv6 pim sparse-mode rp nexthop 3ffe:10:10:5::153
nexthop command
Type
Nexthop Nexthop Nexthop
Num
Addr
.RS.
1
fe80::20e:cff:fe01:facc
command
Parameter
Description
Destination
The destination address for which PIM-SMv6 requires next hop
information.
Type
The type of destination, as indicated by the Flags description. N =
New, R= RP, S = Source, U = Unreachable.
Nexthop Num
The number of next hops to the destination. PIM-SMv6 always
uses only 1 next hop.
Nexthop Addr
The address of the primary next hop gateway.
Nexthop
The interface on which the next hop gateway can be reached.
IfIndex
Nexthop Name
The name of next hop interface.
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
Specify the RP group address used to display next hop RP
information, entered in the form X:X::X:X.
Nexthop Metric
Ifindex
Name
"Getting Started
Guide.
Pref
Refcnt
2
30
110
1
1316