Ipv6 Pim Bsr-Border - Allied Telesis x310-26FT Command Reference Manual

PIM-SM 6 C
V OMMANDS
6 -
IPV PIM BSR BORDER

ipv6 pim bsr-border

Overview Use the ipv6 pim bsr-border command to prevent Bootstrap Router (BSR)
messages from being sent or received through a VLAN interface. The BSR border is
the border of the PIM-SMv6 domain.
Use the no variant of this command to disable the configuration set with ipv6 pim
bsr-border.
ipv6 pim bsr-border
Syntax
no ipv6 pim bsr-border
Mode Interface Configuration for a VLAN interface.
Usage When this command is configured on a VLAN interface, no PIM-SMv6 BSR
messages will be sent or received through the interface. Configure an interface
bordering another PIM- SMv6 domain with this command to avoid BSR messages
from being exchanged between the two PIM-SMv6 domains.
BSR messages should not be exchanged between different domains, because
devices in one domain may elect Rendezvous Points (RPs) in the other domain,
resulting in loss of isolation between the two PIM domains that would stop the
PIM-SMv6 protocol from working as intended.
Examples The following example configures the VLAN interface vlan2 to be the PIM-SMv6
domain border:
awplus#
awplus(config)#
awplus(config)#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
The following example removes the VLAN interface vlan2 from the PIM-SMv6
domain border:
awplus#
awplus(config)#
awplus(config-if)#
C613-50103-01 REV A
configure terminal
ipv6 forwarding
ipv6 multicast-routing
interface vlan2
ipv6 enable
ipv6 pim bsr-border
configure terminal
interface vlan2
no ipv6 pim bsr-border
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
1272