Auth-Mac Method - Allied Telesis x310-26FT Command Reference Manual

A C
UTHENTICATION OMMANDS
-
AUTH MAC METHOD

auth-mac method

Overview This command sets the type of authentication method for MAC-Authentication
that is used with RADIUS on the interface specified in the Interface command
mode.
The no variant of this command resets the authentication method used to the
default method (PAP) as the RADIUS authentication method used by the
MAC-Authentication.
auth-mac method [eap-md5|pap]
Syntax
no auth-mac method
Default The MAC-Authentication method is PAP.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port; or Authentication Profile mode.
To set the MAC-Authentication method to pap on interface port1.0.2, use the
Examples
following commands:
awplus#
awplus(config)#
awplus(config-if)#
To set the MAC-Authentication method to the default on interface port1.0.2,
use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
To enable MAC authentication on authentication profile 'student', use the
commands:
awplus#
awplus(config)#
awplus(config-auth-profile)#
C613-50103-01 REV A
Parameter Description
eap-md5
Enable EAP-MD5 of authentication method.
pap
Enable PAP of authentication method.
configure terminal
interface port1.0.2
configure terminal
interface port1.0.2
configure terminal
auth profile student
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
auth-mac method pap
no auth-mac method
auth-mac enable
1632