Table of Contents
Advertisement
PIM-SM C
OMMANDS
-
IP PIM SPT
THRESHOLD
ip pim spt-threshold
Overview
This command turns on the ability for the last-hop PIM router to switch to SPT
(shortest-path tree).
The no variant of this command turns off the ability for the last-hop PIM router to
switch to SPT.
NOTE
not at all; it is not rate-based.
ip pim spt-threshold
Syntax
no ip pim spt-threshold
Mode
Global Configuration
Examples
To enable the last-hop PIM-SM router to switch to SPT, use the following
commands:
awplus#
awplus(config)#
To stop the last-hop PIM-SM router from being able to switch to SPT, use the
following commands:
awplus#
awplus(config)#
Related
ip pim spt-threshold group-list
Commands
C613-50103-01 REV A
: The switching to SPT happens either at the receiving of the first data packet, or
configure terminal
ip pim spt-threshold
configure terminal
no ip pim spt-threshold
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
1240
Advertisement
Table of Contents
