(Ipv6 Access-List Named Protocol Filter) - Allied Telesis x310-26FT Command Reference Manual

IP 6 H A C
V ARDWARE CCESS ONTROL
( 6 -
IPV ACCESS LIST NAMED PROTOCOL FILTER

(ipv6 access-list named protocol filter)

Overview Use this ACL filter to add a filter entry for an IPv6 source and destination address
and prefix, with an IP protocol type specified, to the current named IPv6 access-list.
If you specify a sequence number, the new entry is inserted at the specified
location. Otherwise, the new entry is added at the end of the access-list.
Note that specifying the send-to-cpu parameter could result in EPSR healthcheck
messages and other control packets being dropped.
The no variant of this command removes a filter entry for an IPv6 source and
destination address and prefix, with an IP protocol type specified, from the current
named IPv6 access-list. You can specify the filter entry for removal by entering
either its sequence number, or its filter entry profile.
[<sequence-number>
Syntax
{deny|permit|send-to-cpu|send-to-mirror|copy-to-cpu|
copy-to-mirror} proto <ip-protocol>
{<ipv6-source-prefix/prefix-length>|
<ipv6-source-address> <ipv6-source-wildcard>|
host <ipv6-source-host>|any}
{<ipv6-destination-prefix/prefix-length>|
<ipv6-destination-address> <ipv6-destination-wildcard>|
host <ipv6-destination-host>|any} [vlan <1-4094>]
no [<sequence-number>]
{deny|permit|send-to-cpu|send-to-mirror|copy-to-cpu|
copy-to-mirror} proto <ip-protocol>
{<ipv6-source-prefix/prefix-length>|
<ipv6-source-address> <ipv6-source-wildcard>|
host <ipv6-source-host>|any}
{<ipv6-destination-prefix/prefix-length>|
<ipv6-destination-address> <ipv6-destination-wildcard>|
host <ipv6-destination-host>|any} [vlan <1-4094>]
no [<sequence-number>]
Parameter
<sequence-number>
deny
permit
send-to-cpu
send-to-mirror
copy-to-cpu
copy-to-mirror
C613-50103-01 REV A
L (ACL) C
IST OMMANDS
)
Description
The sequence number for the filter entry of the selected access control
list, from 1 to 65535.
Specifies packets to reject.
Specifies packets to permit.
Specifies packets to send to the CPU. Specifying this parameter could
result in EPSR healthcheck messages and other control packets being
dropped.
Specifies packets to send to mirror port.
Specifies packets to copy to the CPU.
Specifies packets to copy to the mirror port.
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
1447