Auth Roaming Enable - Allied Telesis x310-26FT Command Reference Manual

A C
UTHENTICATION OMMANDS

AUTH ROAMING ENABLE

auth roaming enable
Overview This command allows a supplicant to move to another authenticating interface
without reauthentication, providing the link is up for the interface that the
supplicant is is currently connected to.
The no variant of this command disables roaming authentication on an interface,
and forces a supplicant to be reauthenticated when moving between interfaces.
See the
for further information about this feature.
auth roaming enable
Syntax
no auth roaming enable
Default Roaming authentication is disabled by default.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port; or Authentication Profile mode.
Usage Note that 802.1X port authentication, MAC-authentication, or Web-authentication
must be configured before using this feature. The port that the supplicant is
moving to must have the same authentication configuration as the port the
supplicant is moving from.
This command only enables roaming authentication for links that are up. If you
want roaming authentication on links that are down, you must also use the
command
Roaming Authentication cannot be enabled if DHCP snooping is enabled
dhcp-snooping
Examples To enable roaming authentication for port1.0.4, when using 802.1X
authentication, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
To disable roaming authentication for port1.0.4, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
To enable roaming authentication for authentication profile 'student', use the
commands:
awplus#
awplus(config)#
awplus(config-auth-profile)#
C613-50103-01 REV A
AAA and Port Authentication Feature Overview and Configuration Guide
auth roaming disconnected.
command), and vice versa.
configure terminal
interface port1.0.4
dot1x port-control auto
auth roaming enable
configure terminal
interface port1.0.4
no auth roaming enable
configure terminal
auth profile student
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
auth roaming enable
(service
1609